FSP200
Tempo Communications Inc.
1390 Aspen Way • Vista, CA 92081 USA • 800-642-2155
32
Error Messages
Error Message
Reason
Solution
Left/Right/L-R fiber set too
close!
•
The fiber end-face is placed on the
electrode centerline, or beyond it.
•
The cleave length (bare fiber part) is too
long.
•
Dust or dirt is on the objective lens or the
wind protector mirror.
•
Confirm the setting position of the stripped
fiber end on the fiber cleaver. Check the cleave
length.
•
Clean the lens or the mirror when dust or dirt
exists.
Left/Right/L-R fiber set too
far!
Reset Left/Right fibers!
Clear Left/Right fibers!
•
Dust or dirt is on the objective lens or the
wind protector mirror.
•
“Cleaning Arc” time is too short or OFF.
•
Splicing indistinct core fibers with the SM
or DS modes.
•
“Align” is set to “Core” to splice indistinct
core fibers when using other splice
modes.
•
“Focus” is incorrectly set when using
other splice modes.
•
Completely prepare the fiber again (strip, clean,
and cleave).
• Clean the lens or the mirror if dust or dirt
exists.
•
Set the “Cleaning Arc” time to “30ms.” When
splicing carbon-coated fibers, set to “100ms.”
• Use the MM mode to splice indistinct core
fibers (i.e., MM fiber).
•
Set “Align” to “Clad” to splice indistinct fibers
(i.e., MM fiber).
•
Set “Focus” to “Edge” to splice indistinct core
fibers (i.e., MM fiber). To splice distinct core
fibers, enter “Auto” or the correct focus value.
Left/Right fiber X/Y set
error!
•
The fiber is not set correctly at the
bottom of the V-groove. The fiber
position is out of focus range.
•
Dust or dirt is on the fiber surface
resulting in focus failure.
•
Dust or dirt is on the objective lens or the
wind protector mirror.
• Press
, and re-position the fiber to seat it
correctly at the bottom of the V-groove.
•
If fibers are not shown, use “screen adjust.”
Follow the procedure displayed to enable the
entire fiber to be displayed.
•
Completely prepare the fiber again (strip, clean,
and cleave).
• Clean the lens or the mirror if dust or dirt
exists.
X/Y Motor out of range!
Cover is open!
The wind protector is opened during
splicing operation.
Press
after closing the wind protector.
Left/Right/L-R fiber angle
errors, shape errors and
clear left & right errors
•
“Core Angle Limit” is set too low.
• Dust or dirt is on the V-groove or the
clamp chip.
•
Bad fiber end-face.
•
The splicer measures the core angle only when
using other splice modes. Increase the “Core
Angle Limit” to an adequate limit. (1.0 degree
is standard.)
•
Clean the V-groove and clamp chip, and set
the fibers again. If the error occurs again, strip,
clean, and cleave the fibers.
•
Check the condition of fiber cleaver. If the
blade is worn, rotate the blade to a new
position.
