Teledyne Princeton Instruments PICam 5.x, Programmer'S Manual

Page: 87 / 357

Chapter 5 Configuration APIs 87
PicamParameter_IntensifierStatus
Reports the status of the intensifier power via the
PicamIntensifierStatus data enumeration.
Refer to Section 5.1.1.15, PicamIntensifierStatus , on page 79
for additional information.
PicamParameter_InternalShutterStatus
Reports the status of the shutter that is internal to the
hardware via the
PicamShutterStatus data enumeration.
Refer to Section 5.1.1.31, PicamShutterStatus , on page 97 for
additional information.
PicamParameter_InternalShutterType
Reports the type of shutter that is internal to, and can be
driven by, the hardware via the
PicamShutterType data
enumeration.
Refer to
Section 5.1.1.33, PicamShutterType , on page 99 for
additional information.
PicamParameter_InvertOutputSignal Controls if the timing signal is inverted when viewed from the
hardware monitor.
PicamParameter_InvertOutputSignal2 Controls if the timing signal is inverted when viewed from the
second hardware monitor.
PicamParameter_KineticsWindowHeight Controls the number of rows used for the sensing window in
a kinetics readout.
PicamParameter_LaserOutputMode Controls when the laser produces light.
Refer to
Section 5.1.1.16, PicamLaserOutputMode , on page 79
for additional information.
PicamParameter_LaserPower
Controls the laser power as a multiplier.
PicamParameter_LaserStatus Reports if the laser is ready.
Refer to
Section 5.1.1.17, PicamLaserStatus , on page 79 for
additional information.
PicamParameter_LaserWavelength
Reports the wavelength of the laser as measured at the
factory.
PicamParameter_LifeExpectancy
Reports the expected lifetime measured in minutes.
PicamParameter_LightSource Controls the light source on the lamp.
Refer to
Section 5.1.1.18, PicamLightSource , on page 80 for
additional information.
PicamParameter_LightSourceStatus
Reports if the light source has stabilized.
Refer to
Section 5.1.1.19, PicamLightSourceStatus , on page 80
for additional information.
PicamParameter_MaskedBottomMargin Controls the number of masked rows akin to active bottom
margin.
PicamParameter_MaskedHeight Controls the number of masked rows akin to active height.
PicamParameter_MaskedTopMargin
Controls the number of masked rows akin to active top
margin.
PicamParameter_ModulationDuration
Controls the time the intensifier is modulating in milliseconds
(mS).
Table 5-23:
PicamParameter
Enumerator Definitions (Sheet 5 of 11)
Enumerator Description