Teledyne Princeton Instruments PICam 5.x, Programmer'S Manual

Page: 88 / 357

88 PICam™ 5.x Programmer’s Manual Issue 11
PicamParameter_ModulationFrequency
Controls the frequency of the intensifier modulation in MHz.
PicamParameter_ModulationOutputSignal
Amplitude
Controls the peak-to-peak amplitude of the user RF output
signal in volts (V).
PicamParameter_ModulationOutputSignal
Frequency
Controls the frequency of the user RF output signal in MHz
PicamParameter_ModulationTracking Controls the tracking of a sequential phase or custom
modulation sequence in metadata via the
PicamModulationTrackingMask data enumeration.
Refer to Section 5.1.1.20, PicamModulationTrackingMask , on
page 81 for additional information.
PicamParameter_ModulationTrackingBit
Depth
Controls the size of one component in a varying sequential
modulation phase or custom modulation sequence.
NOTE: This metadata is floating point.
PicamParameter_NondestructiveReadout
Period
Controls the rate at which the hardware will non-
destructively readout during exposure in seconds (S).
NOTE:
This duration must be less than exposure time for
any non-destructive readouts to occur.
PicamParameter_NormalizeOrientation Controls automatic orientation correction for data due to
readout ports used.
PicamParameter_OnlineReadoutRate
Calculation
Reports the fastest possible readout rate that could occur
given the current setup and accounting for possible changes
to online hardware parameters while acquiring
PicamParameter_Orientation
Reports the orientation of the data via the
PicamOrientationMask data enumeration.
Refer to Section 5.1.1.21, PicamOrientationMask , on page 81
for additional information.
PicamParameter_OutputSignal
Controls what timing signal is issued from the hardware
monitor via the
PicamOutputSignal data enumeration.
Refer to Section 5.1.1.22, PicamOutputSignal , on page 82 for
additional information.
PicamParameter_OutputSignal2
Controls what timing signal is issued from the second
hardware monitor via the
PicamOutputSignal data
enumeration.
Refer to
Section 5.1.1.22, PicamOutputSignal , on page 82 for
additional information.
PicamParameter_PhosphorDecayDelay Controls the length of time the hardware waits for the
phosphor to decay before reading out. The time unit depends
on
PicamParameter_PhosphorDecayDelay Resolution .
PicamParameter_PhosphorDecayDelay
Resolution
Controls the time unit used for phosphor decay delay. This
value is in microseconds (

S).
Example: A resolution of:
• 1 signifies delay is in microseconds (

S);
• 1000 for milliseconds (mS);
• 0.01 for tens-of-nanoseconds (nS).
Table 5-23:
PicamParameter
Enumerator Definitions (Sheet 6 of 11)
Enumerator Description