Installation instructions
│
T24
│
Chapter 9: Configuration menu
9.1 5 C onf igu re repeater sl ot ID
The slot ID corresponds to the position of a repeater in a chain of one to up to
fifteen repeaters (0–14). By default, the first repeater in the chain will take
slot ID
0.
IMPORTANT! To be able to communicate with each other, the repeater, the
receiver and the transmitter must have the same configuration ID. The
configuration ID is set in SM (V or higher).
IMPORTANT! It is strongly recommended to have only one repeater powered up
and in range of the transmitter when performing configuration via radio.
NOTE: The transmitter must be registered in a receiver for the repeater
configuration procedure to be successful. If the transmitter is not registered in a
receiver, the display will show:
[No RX are registered in this TX. Cannot
start the repeater config]
.
Register the transmitter in the receiver (see
"9.4 Register a transmitter in a
) before proceeding with the configure repeater instruction.
1. Make sure that the
Stop
button is pressed.
2. Twist and release the
Stop
button.
The initial start-up logo is displayed.
Battery indicator(s) light(s).
The
display shows:
[Session Selection]
3. Enter
Menu mode
(see
"9.2 Enter Menu mode (no PIN code required) "
).
4. Navigate to the
[Repeater Configuration]
menu using the
Up/Down
buttons.
5. Press the
Select
button to enter.
The display shows:
[Searching for repeater within range. Please
wait...]
6. Place the repeater within 1 m from the transmitter or quickly tap the
repeater's function button five times to put it in configuration mode.
If a repeater responds within 30 s:
If no repeater has responded within
30 s:
The display shows:
[Repeater
Configuration]
highlighted in black.
The display shows:
[Got timeout
while polling for repeater]
66
IM-PM-TX101-EN-v08
