Installation instructions
│
T24
│
Chapter 9: Configuration menu
9.6 Repl ace a transmitter
It is possible to replace a registered transmitter with another transmitter. The
procedure does not require to open the receiver housing but the receiver needs to
be powered up and within transmission range. Use the transmitter that will replace
the old transmitter to perform the following instructions.
RISK OF UNINTENDED EQUIPMENT OPERATION
Do not perform this action when the receiver is in a session with another
transmitter. The radio communication may be interrupted or broken.
Failure to follow these instructions could result in death, serious injury,
or equipment damage.
IMPORTANT! If the transmitter already has receivers registered, it is recommended
to erase them all from the transmitter before starting the replacement. The
receiver will automatically be stored in the same location as in the old
transmitter. If this location is no longer available, the replacement will fail.
If the transmitter being replaced is registered in more than one receiver, it will
only be replaced in one receiver at a time. To replace a transmitter in more than
one receiver, the replacement procedure must be completed for each receiver.
1. Make sure that the
Stop
button is pressed.
2. Twist and release the
Stop
button.
The initial start-up logo is displayed.Battery indicator(s) light(s).
The display
shows:
[PUSH START BUTTONS]
.
3. Enter
Menu mode
(see
"9.2 Enter Menu mode (no PIN code required) "
).
4. Navigate to the
[Replace]
menu using the
Up/Down
buttons.
5. Press the
Select
button to enter.
The display shows:
[Replace 000000]
6. Enter the SN number (6 digits) of the transmitter to be replaced using the
Up/Down
buttons.
7. Press the
Select
button to confirm.
The display returns to the menu list.
56
IM-PM-TX101-EN-v08
