Installation instructions
│
T24
│
Chapter 9: Configuration menu
9.7 C l ear bl ocked inpu ts
On start up, the T24 transmitters perform a zero position check for control
switches, joysticks and/or paddles.
If the transmitter detects that some control
commands are not in the zero position, the
following warning message is displayed:
[One or more inputs are not
in the zero/startup position]
[Release all controls to
proceed.]
If the affected controls are not released, the
transmitter will block the corresponding inputs
and display the error message:
[Zero position problem
identification in progress.]
[Please wait for device to
automatically restart]
The next time the transmitter is started, the
display will show the warning message:
[Inputs have been blocked.]
[IO board 0X: 0xXXXXXXXX]
.
To clear the locked inputs:
1. Make sure that the
Stop
button is pressed.
2. Twist and release the
Stop
button.
The initial start-up logo is displayed.
Battery indicator(s) light(s).
The
display shows:
[Session Selection]
3. Enter
Menu mode
(see
"9.2 Enter Menu mode (no PIN code required) "
).
4. Navigate to the
[Clear blocked input]
menu using the
Up/Down
buttons.
5. Press the
Select
button to enter.
The display shows:
[Value: False]
6. Press the
Up
or
Down
button to change
[False]
to
[True]
.
7. Press the
Select
button to confirm.
The display returns to the menu list.
l
If successfully completed, at next start-up:
The display shows:
[Session Selection]
l
If not successfully completed, at next start up:
The display shows:
[Inputs have been blocked.]
[IO board 0X: 0xXXXXXXXX]
.
Go back to step 1 and try again.
IM-PM-TX101-EN-v08
57
