Installation instructions
│
T24
│
Chapter 8: Operation
8 .6 S tart a session
To be able to control a receiver using the transmitter, the transmitter must be
registered and logged in to a receiver.
When not in use, transmitters must be switched off and stored in a
secure storage space.
Do not use the system if the stop button is damaged or if it does not
stop the equipment. Doing so could result in serious injury or death.
NOTE: If the transmitter has never been logged in to the receiver before, the
start-up procedure will fail and the transmitter will turn off.
Start the transmitter again and log in to a receiver before proceeding with the
start-up procedure (see
"8.5 Log the transmitter in to a receiver"
).
NOTE: The last accessed receiver(s) will automatically be selected the next time
the transmitter is started.
1. Make sure that all safety measures have been followed.
2. Make sure the transmitter battery is charged.
3. Make sure that the
Stop
button is pressed.
4. Twist and release the
Stop
button.
The initial start-up logo is displayed.
Battery indicator(s) light(s).
The
display shows:
[PUSH START BUTTONS]
NOTE: If the display shows a warning message on zero position for the
control switch or joystick, release the affected controls in order to proceed.
If the controls are not released, the transmitter will block the
corresponding outputs and display the following warning message:
[Inputs
have been blocked. IO board 0X: 0xXXXXXXXX]
.
Enter
Menu mode
to clear the locked inputs before proceeding with the
start-up procedure (see
[Inputs have been
blocked. IO board 0X: 0xXXXXXXXX]
.
5. Press the
Select
button to check if there are receiver(s) selected for the
session.
44
IM-PM-TX101-EN-v08
