Tektronix WCA200A, User Manual

Page: 368 / 454

File Operations
3- 242
WCA230A & WCA280A User Manual
Saving and Loading Files
The following procedures show how to save and load files.
You can use a 2HD (1.44 M bytes) or 2DD (720 K bytes) 3.5-inch disk formatted
for MS-DOS. The disk drive is on the side panel. See Figure 2--3 on page 2--5.
Use the following steps to save settings or waveforms to a file. There are two
ways to save data to a file: using the preset file name and entering a new file
name. To return to the previous menu, press the Cancel - Back side key at
any time.
NOTE
. You cannot save data in an existing file.
1.
Press the
SAVE
key on the front panel.
2. Press one of the following side keys, depending on the type of data to save:
Table 3- 31: File save operation
Meas. mode Side key Save content Ext.
S/A
( t R l Ti )
Save State Current instrument settings .sta
(except Real Time) Save Trace 1
Trace 1 waveform .trc
Save Trace 2 Trace 2 waveform .trc
Save Correction Amplitude correction data .cor
Real Time S/A Save State Current instrument settings .sta
Save Data Acquired data in time domain .iqt
Demod / Time Save State Current instrument settings .sta
Save Data... Acquired data in time domain .iqt
All Blocks Data of all blocks
Current Block Data of the block currently displayed
Current Area Data currently shown in the main view
3. To enter a new file name, skip to step 5.
Using a Disk
Saving a File