Tektronix WCA200A, User Manual

Page: 280 / 454

Trigger
3- 154
WCA230A & WCA280A User Manual
A Save-on-Trigger function is provided to save one block of input data to the
IQT file each time a trigger occurs. This function is enabled when the trigger
mode is set to Triggered. For details of file operations, refer to page 3--239.
The file name and location are as follows:
H
File name: yyyymmdd--hhmmss-- ticks .IQT
Where
yyyy is the year, mm the month, and dd the date.
hh is the hour, mm the minutes, and ss the seconds.
ticks is the time stamp of the final frame.
(Refer to unsigned long ticks on page 3--256.)
Example: 20050721--140120--0000154761.IQT
H
Directory:
C:\Documents and Settings\<username>\My Documents\Save--on--Trigger\
Use the following Trigger menu items to control the Save-on-Trigger function:
Save On Trigger . Enables and disables the Save-on-Trigger function.
H
On. Enables the Save-on-Trigger function
H
Off. Default. Disables the Save-on-Trigger function
Save Count . Selects whether or not to set a limit on the number of times that
data is saved.
H
On. Default . When the number of data save operations reaches the Save
Count Limit indicated below, data saving is halted.
H
Off. No limit on data save operations is set. In this case, data saving is halted
using the RUN/STOP key on the front panel or the GPIB command.
NOTE
. When the internal hard disk becomes full, data saving is halted and the
“Media full” error message appears.
For deleting a file, refer to page 3--250.
Save Count Limit . Sets a limit on the number of times that data is saved. This
setting is enabled when the above-mentioned Save Count is On.
Setting range: 1 to 16383 (default: 100)
Data Saving on Trigger