Tektronix TDS5054, User Manual

Page: 40 / 361

TDS5000 Series User Manual
1- 19
Incoming Inspection
This section contains instructions for performing the incoming inspection
procedure. This procedure verifies that the oscilloscope is operating correctly
after shipment, but does not check product specifications. This procedure
contains the following parts:
H
Self Tests on page 1--20 provides instructions for performing the internal
self tests.
H
Functional Tests on page 1--21 measures the time- and amplitude-reference
signals at the PROBE COMPENSATION connector.
H
Perform the Extended Diagnostics on page 1--30 provides instructions for
performing internal self calibration and the extended diagnostics.
If the oscilloscope fails any test within this section, it may need service. To
contact Tektronix for service, see
Contacting Tektronix on page xv of Preface.
Make sure you have put the oscilloscope into service as detailed in Installation
starting on page 1--5. Then assemble the following test equipment before
proceeding with the tests.
Assemble Equipment
Self tests do not require any test equipment. The functional tests require:
H
One passive 10X oscilloscope probe (P5050 or equivalent)
H
One 1.44 MB, 3.5 inch, formatted floppy disk