![Tektronix TDS5054 User Manual Download Page 330](http://html1.mh-extra.com/html/tektronix/tds5054/tds5054_user-manual_1078190330.webp)
Glossary
TDS5000 Series User Manual
Glossary- 3
Cursors
Paired markers that you can use to make measurements between two waveform
locations. The oscilloscope displays the values (expressed in volts or time) of
the position of the active cursor and the distance between the two cursors.
Cycle area
A measurement of waveform area taken over one cycle. Expressed in
volt-seconds. Area above ground is positive; area below ground is negative.
Cycle mean
An amplitude (voltage) measurement of the arithmetic mean over one cycle.
Cycle RMS
The true Root Mean Square voltage over one cycle.
DC coupling
A mode that passes both AC and DC signal components to the circuit.
Available for both the trigger system and the vertical system.
Delay measurement
A measurement of the time between the middle reference crossings of two
different waveforms.
Delay time
The time between the trigger event and the acquisition of post trigger data.
Digitizing
The process of converting a continuous analog signal such as a waveform to a
set of discrete numbers representing the amplitude of the signal at specific
points in time. Digitizing is composed of two steps: sampling and quantizing.
Display
The part of the oscilloscope that shows waveforms, measurements, control
windows, status, and other parameters.
Fast Acquisition mode
A mode that increases the waveform capture rate to up to 200,000 wave-
forms per second. This very fast capture rate greatly increases the probability
that runts, glitches, and other short term changes will accumulate in
waveform memory. The oscilloscope then displays the waveform at the
normal display rate using variable or infinite persistence. This display mode
emulates the display of an analog oscilloscope.
Edge trigger
Triggering occurs when the oscilloscope detects the source passing through a
specified voltage level in a specified direction (the trigger slope).
Envelope acquisition mode
A mode in which the oscilloscope acquires and displays a waveform that
shows the variation extremes of several acquisitions.
Summary of Contents for TDS5054
