5
Using TRIGGER Controls
TDS1000B and TDS2000B Series Oscilloscopes – Operator Training Kit
5-13
The following procedure enables you to use an external
trigger source or an unused channel, other than the
displayed acquisition input channels, to trigger a displayed
signal. You can use the external trigger input (or an unused
channel) to trigger on certain unique aspects of this trigger
signal, such as pulse width and edge level.
To use an external (or an unused channel) input
as a trigger, follow these steps:
1. Connect the CH1 probe tip to the
PSEUDO RANDOM
signal on pin 5 and the CH1 ground lead to
GND
on pin
7 of the Training 1 signal board.
2. On the top of the front panel, push the
DEFAULT
SETUP
button.
3. On the Training 1 signal board, push the
POWER
button
until the
Digital PWR
LED is on.
Summary of Contents for TDS1000B Series
Page 2: ......
Page 8: ...Environmental Considerations TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 14: ...vi TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 316: ...Appendix B Glossary B 10 TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...