6
Using Menu Function Controls
TDS1000B and TDS2000B Series Oscilloscopes – Operator Training Kit
6-55
AUTORANGE Menu Function Controls
You use the
AUTORANGE
Menu Function Controls to have
the oscilloscope automatically track and adjust settings as a
signal changes.
Automatic Adjustment of Oscilloscope Settings
In the following procedure, you watch the AUTORANGE
function automatically adjust settings as you move probe
from one point to another.
To watch the AUTORANGE function in action, follow these
steps:
1. Connect the CH1 probe tip to the
CLK 20 MHz
signal on
pin 2 and CH1 ground lead to
GND
on pin 1of the
Training 1 signal board. Make sure no other channel is
connected to a signal.
2. On the Training 1 signal board, push the
POWER
button
until the
Digital PWR
LED is on.
3. On the top of the front panel, push the
DEFAULT
SETUP
menu button.
4. On the top of the front panel, push the
AUTOSET
button.
5. On the top of the front panel, push the
AUTORANGE
button.
Summary of Contents for TDS1000B Series
Page 2: ......
Page 8: ...Environmental Considerations TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 14: ...vi TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 316: ...Appendix B Glossary B 10 TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...