6
Using Menu Function Controls
6-16
TDS1000B and TDS2000B Series Oscilloscopes – Operator Training Kit
Selecting the Display Type
You can select different display types, such as a vector or a
dot display type, for a waveform by using the options of the
DISPLAY menu. When you choose
Vectors
, straight lines
connect the sample points on the display. When you choose
Dots
, only the sample points are displayed.
The following procedure enables you to change the
appearance of a waveform by changing the display
selections for a waveform.
1. Connect the CH1 probe tip to the
D-10 MHz
signal on
pin 3 of the Training 1 signal board. Connect the CH1
probe ground lead to
GND
on pin 1 of the Training 1
signal board. Make sure that CH1 is the only signal
connected to the oscilloscope.
2. On the Training 1 signal board, push the
POWER
button
until the
Digital PWR
LED is on.
3. On the top of the front panel, push the
DEFAULT
SETUP
menu button.
4. On the top of the front panel, push the
AUTOSET
button.
Summary of Contents for TDS1000B Series
Page 2: ......
Page 8: ...Environmental Considerations TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 14: ...vi TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 316: ...Appendix B Glossary B 10 TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...