5
Using TRIGGER Controls
TDS1000B and TDS2000B Series Oscilloscopes – Operator Training Kit
5-17
Triggering on a Specific Pulse Width
A TDS1000B/TDS2000B oscilloscope can be set to trigger
on a pulse based on its width. This feature can be used to
isolate and analyze a unique pulse in a complex data
stream.
The following procedure enables you to detect the presence
of a unique pulse in a pseudo random digital signal.
This procedure assumes that the oscilloscope retains the
settings from the previous procedure.
To use the pulse width triggering feature, follow these
steps:
1. On the top of the front panel, push the
DEFAULT
SETUP
button.
2. On the Training 1 signal board, push the
POWER
button
until the
Digital PWR
LED is on.
3. On the top of the front panel, push the
AUTOSET
button.
Summary of Contents for TDS1000B Series
Page 2: ......
Page 8: ...Environmental Considerations TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 14: ...vi TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...
Page 316: ...Appendix B Glossary B 10 TDS1000B and TDS2000B Series Oscilloscopes Operator Training Kit ...