Tektronix LTA7P Series, Service Manual

Page: 62 / 172

Performance Verification: Logic Analyzer Module
4- 14
TLA7Nx, TLA7Px, & TLA7Qx Logic Analyzer Module Service Manual
9. The program lists sequences for PV (performance verification) and ADJ
(adjustments). Enter a number to select which sequence you want and click
Enter to continue.
10.
If an instrument is being tested, the program lists the different probe types
available for testing. Enter the appropriate number corresponding to your
probe and then click Enter to continue.
11. Enter the operating temperature in degrees C (entries in the range of 20 to 30
degrees are valid). Click Enter to continue.
12. Enter the operating humidity as a percentage (0% to 100% entries are valid).
Click Enter to continue.
13. Determine which sequence to run:
H
RUN FULL SEQUENCE runs the entire sequence from beginning to
end. This is the recommended selection.
H
RUN PARTIAL SEQUENCE runs part of the full sequence. The
sequence runs from the selected starting point to the end of the sequence.
H
SELECT TEST(S) runs only the selected tests. To run a single test, enter
the test number. To run multiple tests, enter a comma-separated list of
numbers or a hyphen-separated list of numbers.
Enter the number next to your choice and click Enter to continue.
14. Follow the on-screen instructions to connect and adjust test equipment.
15. When testing is completed, disconnect the test equipment.
While the program is running, you can interrupt the program to rerun a test, start
over, or to exit the program by clicking the Interrupt button (shown below).
The program will then provide a list of choices. Enter the number next to the
choice that you want and click Enter.
NOTE
. If you interrupt a test before it has completed, you must restart the test to
obtain valid test data.
Some tests such as Internal Cal do not allow interrupts. If you stop these tests
using more aggressive methods, you may have to reboot the instrument.
Using the Interrupt Button