Tektronix LTA7P Series, Service Manual

Page: 114 / 172

Removal and Installation Procedures
6- 6
TLA7Nx, TLA7Px, & TLA7Qx Logic Analyzer Module Service Manual
Injector/Ejector Handles
You will need a screwdriver with a size T-10 Torx tip to replace the injector/ejec-
tor handles.
Use the following procedure and Figure 6--1 to remove the injector/ejector
handles.
1.
Place the module on the right side (see Figure 6--1).
2. Remove the two screws that secure the injector/ejector handle to the chassis.
3. Remove the injector/ejector handle from the module.
Ejector handles (2)
Remove screws (4)
Figure 6- 1: Injector/ejector handle replacement
Use the following procedure and Figure 6--1 to install the injector/ejector
handles.
NOTE
. The top and bottom injector/ejector handles are not interchangeable. The
top injector/ejector handle assembly has a notch on right side and a tab on the
left side; the bottom injector/ejector handle assembly does not have a notch or a
tab.
1. Install the injector/ejector handle through the front panel cutout onto the
mounting post.
Removal
Installation