Performance Verification
P6467 High-Speed Probe Adapter Instruction Manual
47
The Trigger menu setups are designed such that the logic analyzer will not
trigger as long as it acquires the correct data patterns. The data patterns from the
HFS 9003 Stimulus System consist of AAAA AA and 5555 55 for each
sequence. Start the logic analyzer from the State Display menu. The logic
analyzer should not trigger; instead the Monitor menu should appear and display
a counter running. The test passes when the counter runs for approximately ten
seconds or the counter value exceeds 1,000,000,000. Manually stop the logic
analyzer to stop the test.
This check verifies the Clock Distribution on the P6467 Probe. Use the same
setups for the HFS 9003 Stimulus System listed in Table 9 on page 41 except for
the frequency–change the frequency to 100 MHz.
1. Refer to Table 14 and set the P6467 Probe jumpers for each one of the clock
configuration setups to verify the proper clock operation.
2. Select F1: START and verify that the logic analyzer does not trigger.
3. Select F1: STOP and check the acquired data.
4. Repeat steps 2 and 3 for each setup in Table 14.
Table 14: Jumper Positions and Clock Cable Connections
Setup
Number
Jumper J1
Jumper J2
Jumper J3
Jumper J4
Clock Distribution Cable Connections
from
to
1
MSTR CLK
NORM
NA
NORM
NA
NA
2
EXT
NORM
NA
NORM
MSTR CLK OUT 1
EXT CLK IN
3
EXT
NORM
NA
NORM
MSTR CLK OUT 2
EXT CLK IN
4
1
NA
NORM
CLK A
NORM
NA
NA
5
2
NA
NORM
MSTR CLK
NORM
NA
NA
1
For this setup, move the blue-labeled probe from OUTPUT DATA B (bottom connector pair) to OUTPUT DATA A (top
connector pair). Move the test signal connection to the INPUT DATA A flex cable connector.
2
For this setup, the logic analyzer should trigger and display zeros instead of the A/5 data.
Clock Distribution Checks
Summary of Contents for 070-9176-00
