teko ASTRA ZITADEL, Quick Start Manual

Page: 54 / 94

54
During testing the detectors, having received the command over the radio, switch on their
indicators for the time of 10 seconds, perform the test and send the results to the Control
Panel. The test progress is displayed in
Mark about passing the test and Date/ Time
columns.
Test results in a form of a relative value of dust, expressed in % for SD detectors, and ac-
tual temperature C
º of the ambient air for HD detectors are displayed in the Dust Lev-
el/Temperature column. Test results are logged.
10.2.2. System outputs testing is available only from the Setup Module interface when
logged in with Engineer PIN.
1) Testing of a system output is performed only in the absence of its assignment to a
logical partition. Therefore, before starting the test it is necessary to de-assign it
from a partition and record settings into the Control Panel, and at the end of the
test - to restore assignment and record settings into the PPKOP again.
2) Right-click on selected output and choose Switch ON or Switch OFF command.
3) Check the output status visually (for LSA and FLA) or by a multimeter.
10.2.3. Testing the voice alerting (including test messages) in any alerting area is availa-
ble from the Monitor interface when it is run with Technician or Operator PIN.
When testing, de-assign
relay output from all par-
titions