Lokommander II Next18 ECU
User Manual firmware 5.10.306
Version 0.5.07
Page 59 of 118
25.
The decoder CV table
The table below contains the full list of available CVs of the Lokommander II decoders with
explanations and examples if available. We recommend that you change your CVs only if you are sure of
their function and the impact of your action. Incorrect CV settings can negatively affect the performance of
the decoder or cause in
correct responses to the commands transmitted to the decoder. The “CV” column
contains the CVs number, the “Default Value” column contains the factory
default value of the CVs (after a
decoder reset, all CVs will have the appropriate value in this column), the column "Value Range" contains
the range of usable values for each CV and the "Description" column contains the name and information
about the CV function as well as the reference to the related chapter.
In the below CV table, the decoder outputs will be referred as OUTx since the output count is decoder
type dependent. OUT1 will stand for FL and so on.
In the table below in the description column the bits value is shown in binary mode and, between
brackets, in decimal mode. So always when the bit binary value is 0, the decimal value will be also 0.
