ISOBUS ECU 1224 User and Instruction maual
|
P00801545 Rev:02 SW:1.0.0
42
The meaningful data related to the current treatment are always saved into the ISOBUS ECU 1224
non-volatile memory. indicators shown on the WORK page, display the data related to the last
treatment suspended. They will be reset only starting a new treatment.
ISOBUS ECU 1224 executes some checks before start/resume a treatment. In particular:
•
The tank shall not be empty: if it is empty the user is requested to fill it and to specify the
amount of product loaded (only if a tank level sensor is not present)
•
The rate set-point must be different from zero.
If one of the above conditions is not fulfilled, a message-box signaling the warning is
shown and the main valve is not opened.
Figure 32
10.4 Operating modes
ISOBUS ECU 1224 can work in different operating modes, both selectable by the user by mean of
the dedicated key in the WORK page (
to pass in
manual mode
and
to pass in
automatic
mode
).
Only the WORK page is affected by the modality setting; all the other pages remain the same.
10.4.1 Manual Mode
This functioning mode is always available and requires only the presence of a VT connected to the
ISOBUS ECU 1224 to show its graphic user interface.
Refer to Figure 18 for a representation of the WORK page in Manual Mode.
This mode the following actions are demanded to the user:
Summary of Contents for GEOline 8410073
