Tecno-gaz Europa B EVO, Instructions For Use Manual

Page: 73 / 218

28
ENGLISH
10 MESSAGES OF ERROR OR ALARMS
Messages of error are emphasized through an Alfa-numerical code, consisting in a letter
and three numbers.
The “E” CODE is relative to errors of the operator, which can be corrected by same
operator.
The “A” CODE is relative to alarms, irregularities of the autoclave, after having carried out
the remedy, if the problem persists it is necessary to request telephonic assistance.
To reset alarms and errors, maintain pressed the buttons here indicated until the
intervention of a
“
BEEP”
10.1 List of error alarm messages
ERROR CAUSE REMEDY
E 200 Low water level Fill tank
E 250
Low level water cleaned up with loadingfrom
demineralizer
Fill tank
E 300 Maximum level used water Empty tank
E 401 Door open Colse door with attention
E 451 Door unlocked Open door and close again
E 461
High temperature in chamber for vacuum test
(above 40° C)
Shut off and wait 10 minutes
A 250 Cycle begins without water Control demineralizer device
A 001 Interrupted cycle Reset and restart cycle
A 011 Irregular pc display
Shut off and restart
autoclave
A 101 Vacuum not reached in 10’ (minutes) Reset and restart cycle
A 111 Vacuum not maintened for first phase VT Reset and restart cycle
A 121 Vaccum not maintened for second phase VT Reset and restart cycle
A 401
Hatch opende during the cycle or problem
closing
Check the closing system
A 501 Pressure not maintened Reset and restart cycle
A 551 Irregular 1° temperature sensor Reset and restart cycle
A 552 Irregular 2° temperature sensor Reset and restart cycle
A 641 Overly high pressure Reset and restart cycle
A 651 Overlay high temperature Reset and restart cycle
A 661 Irregular temperature comparison Reset and restart cycle
A 701 Working pressure not reached Reset and restart cycle
A 751 Low temperature Reset and restart cycle
A 761 Irregular pressor sensor Reset and restart cycle
If an alarm message is displayed (CODE “A”) the cycle is to be considered
aborted: it will be necessary to repeat all the preparation and sterilization
operations.
B-DOOR + B-PUMP + B-SELECT