100BASE-T1 SPY 12 Port
User Manual
58
8
ADDITIONAL INFORMATION
•
The propagation delay of the 100BASET1_SPY is constant 1.4
µ
s between two
BroadR-Reach Ports in SPY mode.
•
As the delay through the 100BASET1_SPY between two BroadR-Reach ports in
only 1.4
µ
s,100BASET1_SPY will not influence a AVB time synchronous network
negatively.
•
If the firmware update failed and the host is still in bootloader mode, please
restart the device and try to update the application again as described in this
manual.
•
If any 100Base-T1 link is shown in red color on the Website, it can be a hardware
or software problem. In this last case, the user needs only to restart the device.
If the problem continues after restarting, is a hardware problem, and the user
should contact us for more support.
•
If the user cannot access to the device Website, please, check the Ethernet
Adapter configuration, and follow the instructions as described in this
manual, assigning the correct IP and subnet mask values.
•
If there was an error during the firmware installation, and the FPGA has no
software, the next message will be shown on the webpage of the device:
Failed to flash the FPGA. Please try updating the board again!
In this case, please wait a few seconds until the HOST LED 1 is blinking and
there is link up on Host Ethernet Port, and then update again the firmware
version.
•
Some Ethernet Adapters must have the VLAN & Packet Priority option disabled.
Please, change this configuration,
going to Ethernet Adapter
Properties/Advanced/Packet Priority & VLAN. If this option is enabled, just
disabled. Otherwise, it should be enabled. Please, check also that there is not
any IP Address configured on the Ethernet Adapter, and the Windows Firewall
is disabled.
Note:
This last solution does not work with Intel Ethernet Adapters.
•
The website is tested with Firefox and Internet Explorer. Firefox is preferred.
Chrome is not supported.
•
Warning:
From firmware version 2.0.0, 100Base-T1_SPY has a new reedboot
updater, not compatible with previous firmware. Please, don’t try to update the
device to a previous release if the 2.0.0 version or higher is installed in the
