100BASE-T1 SPY 12 Port
User Manual
21
3.4.3
100BASE-T1 Port
The BR-1A to BR-6B labels on right side allow the user to configure BroadR-Reach Port
settings:
Figure 3-9: Parameters to set in BroadR-Reach Ports
BroadR-Reach mode:
Here the user can select Master/Slave Mode of the selected
Port. On each BroadR-Reach link there has to be one
master
and one
slave
device.
Please set the “BroadR
-
Reach mode” to the opposite of what the
device which is
connected to this port.
Output level:
The “Output Level” is the amplitude level of the BroadR
-Reach signal. The
user can set Full level (Fullout = default) or half amplitude.
Note:
Both devices of one BroadR-Reach link have to use the same level. Otherwise
the user will get an instable link.
FullOut
Level is always recommended.
Test Mode:
For BroadR-Reach Ports it is possible to set a
BroadR-Reach Physical Layer
Test Mode.
There are five test modes defined in the BroadR_Reach Specification to
check the compliance of a port.
