100BASE-T1 SPY 12 Port
User Manual
24
3.4.4
CAN Port
Figure 3-11: Parameters to set in CAN Ports (in figure CAN-A Port)
The CAN-A to CAN-E labels on the left allow the user to configure:
Note:
In firmware 2.0 there are only three CAN-Ports available (CAN-A to CAN-C) due
to perfomance. CAN-D and CAN-E can be activated by another Firmware, but then there
is 100BASE-T1 functionallity not avaliable anymore. For further information please get
in contact with
Output to:
Allows to select which Gigabit port will be used to output logging data of
selected CAN port. To activate the port logging, the Header must be enabled in the
Spy
Multiplexer
page (see Chapter 5.4.2.)
CAN Type:
Allows to select between CAN 2.0, nonISO or ISO CAN-FD operation mode.
CAN mode:
Allows to select if the CAN port is working as Passive or Active Node. In
both modes, the 100BASET1_SPY 12 Port will log the information. In the Passive Node
mode the device will not send ACK signals.
