100BASE-T1 SPY 12 Port
User Manual
54
7
APPLICATION FIRMARE UPDATE
The user can download the latest firmware and documentation for the
100BASET1_SPY here:
https://technica-engineering.de/en/produkt/100base-t1-spy_12-port/
Note:
If the user updates the application the bootloader should also be updated to the
latest version.
Warning:
Not following these instructions may cause erroneous states of the device.
The user will have to send it back to Technica Engineering for repair. Technica
Engineering may charge support fees for this service.
Note:
The user needs to have administration privileges on a Windows PC to be able to
do the firmware update on the 100BASET1_SPY
The application firmware of the device may be updated by the following process:
1.
Power up the device by a stable 12 Volt DC power supply. Do
not
switch off the
power supply during the update process.
2.
It is recommended to connect the Wake-up line (Pin 8 of the black MQS
connector) to 12 Volt of the same power supply to make sure the ECU is awake
during update.
3.
Disconnect all other Ethernet, CAN, FlexRay, LIN and BroadR-Reach links from
the 100BASET1_SPY.
4.
Disable the Firewall
of the Windows PC. Set the network device of the PC to the
same subnet as the 100BASET1_SPY. (For example 192.168.0.100 and
255.255.0.0)
5.
Check that the firmware package that the user received from Technica
Engineering contains the following files:
redtool.exe microcontroller.crc.srec redboot.srecspy.srec
UpdateAll.bat
The user will need to have java installed on the PC.
6.
Check that the “Host” LED toggles slowly (so the device is running in application
mode).
7.
Check that the website at 192.168.0.49 can be accessed (or whatever the IP
address of the 100BASET1_SPY is configured for).
8.
Run UpdateAll.bat file in Administrator mode
