29
TEC-67231-2 Technical description Prizrak-8xx BT
Configuring the remote/automatic engine start feature
Table 12. Remote/automatic engine start feature settings
№
Option name
Values
range
Default
values
Note
1 «Free hands» function during remote start mode
1 – 3
2
1 – The CDL is unlocked after RFID tag is identified,
engine will keep running; 2 – OFF; 3 – Engine shuts
down when RFID is identified, CDL will remain locked
2 ESM-250 module remote start diagram
3 – 27
3
Set up one of the standard remote start schemes
(timing diagrams). All timing diagrams can be found
in TECprog2, Any timing diagram may be customized
according to specific needs
3 «Ignition support» feature
1 – 2
2
1 — enabled; 2 — disabled
4 Engine run time in the ignition support mode
1 – 15
5
1 — 1 minute; 2 — 2 minutes; 3 — 3 — minutes; 4 — 10
minutes; 5 — 20 minutes; ... 15 — 120 minutes
5 «Turbotimer» function
1 – 5
1
1 — enabled; 2 — operation time 1 minute;
3 — 2 minutes; 4 — 3 minutes; 5 — adjusts
automatically
6 External temperature sensor function
(connected to ESM-250)
1 – 2
2
1 — engine temperature sensor;
2 — interior temperature sensor
7 Ignoring brake pedal application when
vehicle is remote started
1 – 3
2
*
1 — brake pedal is ignored when the vehicle is being
remote started; 2 — brake application cancels the
remote start; 3 — the brake pedal is ignored during the
entire remote start cycle
8 Engine shut down after releasing the brake pedal
1 – 2
2
*
1 — enabled; 2 — disabled
9 Brake pedal engaging via CAN-bus
1 – 2
2
*
1 — enabled; 2 — disabled
10 Engine shutdown when disarming
1 – 2
2
*
1 — enabled; 2 — disabled
11 Engine shutdown conditions during
remote start mode
1 – 3
1
1 — by time; 2 — by engine temperature;
3 — by engine temperature or by time
12 Engine type
1 – 3
1
1 — diesel; 2 — petrol; 3 — hybrid
13 Starter crank delay (for diesel)
1 – 20
2
1 — 1 sec; ...20 — 20 sec
14 Engine’s RPM at idle speed
1 – 6
–
1 — 600 RPM;...6 — 1100 RPM. It is adjusted
automatically, can be set up manually if needed
15 Engine run time during remote start mode
1 – 12
3
1 — 10 minutes;...3 — 30 minutes;...12 — 120 minutes
16 Engine shutdown temperature during
remote start mode
1 – 14
12
1 — «15°С»; 2 — «20°С»; ... 12 — «70°С»; ...
14 — «80°С»
17 Low-temperature engine start
1 – 8
1
1 — «-30°С»; 2 — «-20°С»; 3 — «-15°С»; 4 — «-10°С»;
5 — «-5°С»; 6 — «0°С»; 7 — «5°С»; 8 — «10°С»
18 Low-battery voltage engine start
1 – 15
8
1 — 10,6 V; 2 — 10,7 V; ... 8 — 11,3 V; 15 — 12 V
19 Engine run time to recharge the car’s battery
1 – 6
3
1 — 10 min;...3 — 30 min;...6 — 60 min
20 Tarnsmission type selection
1 – 4
–
1 — Automatic transmission(AT); 2 — Manual
transmission (MT); 3 — control is not preformed;
4 — manual transmission with «neutral» status; Adjusts
automatically, can be set up manually if needed
21 «Remote engine start» feature
1 – 2
2
1 — ON; 2 — OFF
22 Driver’s door opening imitation ignore duration
(for third-party remote start modules only)
1 – 5
1
1 — ignore disabled (getting out of the vehicle imitation
is also disabled); 2 — 1,0 sec; 3 — 3sec; 4 — 5 sec;
5 — all doors are ignored starting from the moment
of remote start command until the engine is actually
started and within 5 sec after the ignition is switched off
23 Driver’s door opening imitation right after remote
start mode is terminated
1 – 5
1
1 — via CAN-bus and pulse 0,4 sec; 2 — pulse — 0,4 sec;
3 —1 ,0 sec; 4 — 4,5 sec; 5 — 3,5 sec
24 CDL automatic re-locking after remote
start is terminated
1 – 2
1
1 — ON; 2 — OFF
25 Vehicle rearming right after remote start mode is
terminated
1 – 2
1
1 — permit; 2 — prohibit
26 Engine pre-heating time with parking heater
1 – 4
2
1 — 10 min;...2 — 20 min;...4 — 40 min
27 Engine pre-heating temperature with parking heater
1 – 10
3
1 — «-10°С»; 2 — «-5°С»; 3 — «0°С»; ... 10 — «50°С»
28 Engine start delay after pre-heating
1 – 5
1
1 — OFF; 2—3 min.; 3 — 5 min; 4 — 10 min; 5 — 15 min
29 Remote engine start control with OEM remote key
1 – 2
2
1 — ON; 2 — OFF
30 Remote engine start via CAN bus
1 – 2
2
1 — ON; 2 — OFF
31 Ignoring all parameters during remote engine start
1 – 2
2
1 — ON; 2 — OFF
32 Enabling remote start ready mode
(manual transmission)
1 – 2
1
1 — by driver’s door closing;
2 — by arming
33 Window wipers are «ON» sonic warning for the
remote start
1 – 2
2
1 — ON; 2 — OFF
34 Time period for «driver’s door opening imitation»
1 – 3
1
1 — after remote start; 2 — prior to remote start;
3 — prior to and after remote start
