6-51
EM18-33017
6. DIAG. TEST OPERATION
Power off
Turn on the power while holding down
the [FEED] key and [PAUSE] key.
< 1
D I A G N O S T I C
V 1 . O A
>
< 4
S E N S O R
A D J U S T M E N T
>
[ T
A N S M I S S I V E ]
2 . 3 V
R
[ T
A N S M I S S I V E ]
4 . 1 V *
R
Press the [FEED] key three times.
Set the label so that the feed gap
sensor can detect the backing
paper (no label). (See NOTE 1.)
The former value is displayed.
Holding the [FEED] key or [RESTART]
key down until an asterisk ( * ) is
displayed. (More than 3 seconds.)
Press the [PAUSE] key for
Paper End Setting for Black
Mark Sensor.
Indicates adjustment complete.
Ex)
Press the [PAUSE] key three times.
Align the backing paper of the
TOSHIBA TEC specified label
with the feed gap sensor.
Label
Feed Gap Sensor
Backing
Paper
Press the [FEED] key
and [RESTART] key
at the same time.
,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,
(See NOTE 2.)
NOTES:
1.
Make sure to adjust the feed gap sensor using the backing paper with no label as
a criterion. Though an adjustment can be performed with the label, it could cause
a paper jam error.
2.
Pressing the [PAUSE] key validates the sensor adjustment. The value of the
sensor is displayed up to 5.0 V.
3.
When the difference is less than 1.5 V, used media may be improper (unspecified),
or sensitivity may be dull due to an excessively old or dirty sensor. In this case
change the media to one specified, or replace or clean the sensor. Then re-
adjustment the feed gap sensor.
(Revision Date: Jan. 14 ‘99)
6.5 SENSOR SETTING MODE
6.5.3
Feed Gap Sensor Adjustment
Feed gap sensor setting should be performed after replacing the CPU PC board or changing the
label to another maker’s, or when a paper feed error occurs.
The feed gap sensor has a movable and a fixed mode. These are selected by the DIP switch.
After changing the feed gap sensor type, fellow the procedure below to make an adjustment.
