Team SILK AX14-60, Instruction Manual, Page: 88 / 92

AX14-60 Flange Facing Machine
87
5. USING THE FALL-STOP KIT
Proceed to install the machine at the worksite following
the information in the operator’s
manual and any site-specific procedures.
ONCE THE MACHINE HAS BEEN CORRECTLY SET DO NOT
REMOVE THE MACHINE CLAMPING SYSTEM SETTING PLATES
UNTIL THE FALL-STOP KIT HAS BEEN PROPERLY ADJUSTED.
Adjust the position of the Fall-stop kit rod and the machining arm so that they overhang
the work piece sufficiently to prevent the machine from falling into the internal opening
should the machine clamping system fail.
When correctly adjusted, securely tighten the machining arm and Fall-stop kit locknut.
The Fall-Stop Kit is now correctly set.
ON COMPLETION OF THE WORK THE FALL-STOP KIT MUST NOT
BE REMOVED FROM THE MACHINE UNTIL THE MACHINE SETTING
PLATES HAVE BEEN RE-INSTALLED.
6. FAULT DIAGNOSIS
6.1 Introduction
A fault diagnosis chart is provided to assist the user to identify basic faults. The chart is
not exhaustive and the recommended action may not be the only solution to a fault.
In order to prevent possible injury to personnel or damage to equipment it
is recommended that faults are corrected as soon as they arise.
6.2 Fault diagnosis chart
Symptom Possible cause Action
Fall-stop kit bracket will not
engage with the keyway. Locating faces are dirty or
damaged Inspect, clean and repair as
necessary.