Team SILK AX14-60, Instruction Manual

Page: 46 / 92

AX14-60 Flange Facing Machine
45
7.4 REMOVAL AND REFIT PROCEDURES
TO PREVENT DAMAGE TO THE MACHINE ALWAYS USE GENUINE SPARES
AVAILABLE FROM TEAM
®
OR ONE OF ITS AGENTS.
The following procedures are given for the removal and refitting of the main assemblies so
that repair work can be carried out.
ENSURE ALL AIR SUPPLIES ARE REMOVED OR ISOLATED PRIOR TO WORK
COMMENCING.
BEFORE ATTEMPTING TO REMOVE OR REFIT ANY ITEM ON THE MACHINE MAKE
SURE THAT THE CUTTING TOOL HAS BEEN REMOVED.
7.4.1 Drive motor removal
1. Remove the location plate from the base plate by using a 4mm A/F Allen key,
remove the 2 off M6 socket head cap screws, place in a secure location for re-
fitting.
2. Remove the 4 off M8 socket head cap screws with a 6mm A/F Allen key from
the base plate, caution as the screws are secured into position with Loctite
Threadlocker.
3. Carefully draw the motor and motor cover away from the gear sleeve and drive
hub assembly, caution as not to damage the O-ring. Place in a secure location.
4. The re-fitting of the motor is the reverse of the removal procedure, but take care
not to overlook the fitting of the O-ring into the gear sleeve.
7.4.2 Surfacing arm removal
1. Observe all Warnings and Cautions; refer to sections 3.1 and 7.4.
2. Attach a suitable lifting apparatus to the surfacing arm.
3. Slacken off the 3 off 19mm A/F nuts and the 2 off 6mm A/F socket head cap
screws located on the slide way clamp. CAUTION, do not remove the cap
screws completely (see Fig. 18).
4. Slacken off the 4 off 10mm A/F socket head cap screws under the slide way
heel clamps (see Fig. 18).
5. Using the lifting apparatus lift the surfacing arm away from the drive hub
assembly.