Teac es8, User Manual

Page: 50 / 69

6.
In detailed setting menu, move the cursor to [OK] without fail, and press [ENTER] to
establish the channel setting.
7.
In the case of multi-channels, make settings of the same operation on the other
channels. And in <Setting> menu, move the cursor to [OK] to establish the setting.
8.
Move the cursor to <Rec Time> and press [ENTER] to set the recording time after
triggering. Input the number of seconds according to the menu which will be shown.
9.
Make settings of the pre-trigger or post-trigger. Move the cursor to <Pre/Post> and
press [ENTER]. According to the menu which will be shown, make the setting of
<Mode> and <Scan> (Specify the range of pre or post-trigger in the scan numbers. The
setting range is the value resulting from 460000/recording channel number).
In ASCII recording, if the GPS information (latitude, longitude, altitude, speed, and
course) is ON, the value will be a maximum of 15000. Even if the setting value exceeds it,
15000 will be set automatically.
10.
Move the cursor to <Logic&Count> and pres [ENTER]. Make the settings of the
trigger logic and trigger count between the multiple trigger monitor channels.
According to the menu which will be shown, make the setting of <Mode> (OR or AND
logic) and input value into <Count>. (Triggering occurs when the trigger condition
comes equal to the number of count set in here. A maximum of 65535 counts)
11.
Move the cursor to <RepeatCount> and press [ENTER]. Set the repetition count of
the trigger for recording. According to the menu which will be shown, input the count
value.
In the case of using the CF memory card, it will be a maximum of 999.
12.
When triggering by an external trigger, move [cursor] to <External> and choose
[ON] by Right/Left key
Page 42