Teac es8, User Manual, Page: 19 / 69

Section 3 Before Recording
3.5. Setting the Date and Time
Adjust internal clock (RTC) in main unit.
1.
Turn the power switch ON to show <MAIN> display.
2.
Press [MENU] five times to show <MISC MENU>.
<MAIN>
→
<SYSTEM MENU>
→
<FILE MENU>
→
<RECCOND MENU>
→
<COMPARATOR MENU>
→
<MISC MENU>
The item shown in <MISC MENU> depends on the status when the system escaped from
this menu through previous operation.
3.
Press Down the key to move the cursor to <Time Set>.
4.
Press [ENTER] to show the time setting display.
The present system time is shown.
RTC 30 seconds calibration
Time calibration is done automatically when RTC 30 sec calibration signal, described in “Section 2
Name & functions of each part Input connector”, is inputted under this status (Under bar is located on
the seconds digit, and the time is counted up). => Returns to <MISC MENU>. (RTC 30 sec
calibration: Falling to Low level initiates the calibration process. If the seconds digit in the internal
clock is within 30sec, the seconds is omitted to set the time. If the seconds digit is over 30sec, the
time is set to 1 minute later automatically.)
5.
The value at the underscore bar can be modified. The underscore bar can be moved
by the Right/Left key. The value can be changed by the Up/Down key. You can modify
the date and times when you want to make settings. If the underscore bar is moved,
time is not counted up
。
6.
While continuing to hold [MENU] key, press [ENTER] key.
The display changes to <MAIN> menu. And, new date and time will be set.
Page 11