Teac es8, User Manual

Page: 29 / 69

Section 5 Basic Recording
Choosing a recording channel
1.
Press the Down key to move to <CH Use> to choose channel to be used for next
recording.
2.
Press [ENTER] to show ON/OFF menu on each channel.
Press the Right/Left key to change the settings to ON/OFF on the channel where the
cursor is located.
Press the Up/Down key to move the cursor to the other channel.
3.
Press the Up key to move the cursor to [OK] after the settings on each channel are
finished.
4.
Press [ENTER] to establish the channel to be used. The system returns to <SYSTEM
MENU>. The channel to be used is shown at <CH Use>.
The left figure shows CH1, 2, 3, 4 which set the recording of the target channel. <ALL>
means that all the channel is set for recording the target channel.
Choosing a recording data format
1.
Press [MENU] to move from <SYSTEM MENU> to <FILE MENU>. The item shown
depends on the status when the system escaped from this menu through previous
operation.
2.
Press the Down key (or Up key in case of another item shown) to move the cursor to
<Data Type>.
3.
Press the Right/Left key to choose the recording data format shown in the bracket.
[TAFFmat]: creates header file of the text format and binary data file. It is TEAC’s
proprietary file format for the digital data recorder. However, the available format may be
changed for some products.
[CSV]: creates a header file in text format and data file in CSV format.
Details related to the data format are described in “Section 7”
CAUTIONS
Set the sampling frequency to 50 kHz or less before choosing the CSV as the recording data format.
In case CSV is chosen as the recording data format and pre-trigger is used, recording finish time will be delayed by seconds of the
pre-trigger.
Page 21