Teac es8, User Manual

Page: 28 / 69

Section 5 Basic Recording
You can make basic settings and recordings using key operations.
5.1. Setting the Recording Parameter
Before basic recording by key operation, some settings of the recording parameter, such as sampling frequency, input range of each
channel, choosing the available channel(ON/OFF of channel), choosing the recording data format, and recording mode, are required to be
made.
Setting the Sampling frequency
1.
Turn the power switch ON to show <MAIN> display.
2.
Press [MENU] to show <SYSTEM MENU>.
The item shown depends on the status when the system escaped from this menu
through previous operation.
3.
Make settings of sampling frequency.
Make sure that the cursor is located on <Sampling>. If not on <Sampling>, press the
Up key to move the cursor to <Sampling>.
4.
Use Right/Left key to show desired sampling frequency in a bracket.
You can choose the value such as 5 kHz, 2 kHz, 1 kHz, 500 Hz, 200 Hz, 100 Hz, 50 Hz,
20 Hz, 10 Hz, 5 Hz, 2 Hz, 1 Hz, 2 Sec, 5 Sec, 10 Sec, 30 Sec, 60 Sec.
The left figure shows a sampling frequency set at 100Hz.
In case [CSV] (ASCII data file) is chosen as a recording data format described later, set
the sampling frequency to 50 Hz or less.
Setting the input range
1.
Set the input range of each channel.
Press the Down key to move cursor to <Range>.
2.
Press [ENTER] to show the range setting menu of each channel.
Press Right/Left key to make settings of the input range of the channel where the cursor
is located. Press Up/Down key to move the cursor to another channel.
While continuing to hold the [MENU] key, press the Right/Left key. The same settings can
be made on other channel simultaneously.
3.
Press Up key to move the cursor to [OK] after the setting is finished.
4.
Press [ENTER] to establish the range of setting. (Display returns to <SYSTEM
MENU>)
Page 20