409-10100
9 of 59
Rev C
methods that are available are Peak Force and FFT. For the FFT analysis there are additional parameters
that can be selected in the Learn mode (see section 4.11)
3. RECEIVING INSPECTION AND INSTALLATION
3.1. Receiving
The Crimp Quality Monitor II (CQM II) is thoroughly inspected during and after assembly. A final series of
inspections is made to insure the proper functioning of the Crimp Quality Monitor II before packaging and
shipping.
However, damage may occur during shipment. Remove the outer bands from the box and carefully remove the
CQM II from the box. Inspect the CQM II for damage. If damage is evident, file a claim against the carrier and
notify TE immediately.
NOTE
i
Save the shipping carton/box and the entire documentation package shipped with the CQM II.
NOTE
i
3.2. Inspection and Installation
1.
After inspecting for damage, install the power supply, plug the cord into the module, and plug the AC
plug into an appropriate supply, and turn the power on. The power indicator light on the front of the CQM II
host module and CQM DAQ module should be lit.
2.
During the system boot process several TE images will appear. After approximately 30-seconds the
system will be ready to accept a Work Order or be presenting a user login screen (depending on the user
settings).
3.
If the power indicator light is not lit or the screen cannot be viewed, turn the power off and notify TE
immediately
The installation instructions for the Crimp Quality Monitor II are included with the appropriate machine interface kit.
F
or example, if the CQM II is being installed on a bench version of the AMP–O–LECTRIC Model “G”
Terminating
Machine, the CQM/GTM Kit is required. The documentation package included with the kit contains the installation
instructions for the system i
nstallation
3.3. System Settings
Touch the system settings icon to bring up the System Settings screen as shown below.
The System Settings is used to set up the basic system configuration.
NOTE
i
The Systems Settings must be performed prior to any CQM settings and before production can be run. It must be
performed by the CQM administrator.
NOTE
i
Any other machine options must also be installed. Do not be confused with the CQM Installed option. In most
configurations this should be selected as installed. Only the AMP 3K/5K (with stripper module installed )could be used
without the CQM installed.
Summary of Contents for Crimp Quality Monitor II
Page 30: ...409 10100 30 of 59 Rev C...
Page 41: ...409 10100 41 of 59 Rev C...
