Pneumatic Ceram Valve
Pneumatic valves are used to control the clamps and carriage cylinders. They require that the air have
minimum water for long term operation. If maintenance is required the pilot override can be used to
test the valve by bypassing the computer system (when the saw is shutdown). Make sure you are
consuming oil as described on page 9 of “Maintenance”.
Note recommended oil for maintenance is Valvoline break cylinder lubricant.
Outfeed Clamps
Outfeed Clamps
Flow Control
(3 turns out)
Flow Control
(3 turns out)
Flow control must be adjusted
on both clamp and unclamp
Flow control must be adjusted
on both clamp and unclamp
Carriage Cylinder
Carriage Cylinder
Infeed Clamps
Infeed Clamps
Pilot Override
(allows you to manually actuate cylinders)
Pilot Override
(allows you to manually actuate cylinders)
Note flow control is used to set how fast the clamps clamp. On the actual clamping
cylinder there is a buffer adjustment (1 turn).
Page 44 Pneumatic Ceram Valves
Summary of Contents for WebSaw
Page 1: ...TCT WebSaw...
