3. Within the “Hyper Terminal” window make sure your caps lock is always turned on. Press the
“Escape” key and then one of the following values.
Note never use number pad to type in numbers.
M1= (Print Direction)
PS=4000 to 4500 (Print Speed, higher number reduces letter spacing)
D1=30 to 40 (Print Delay, higher number reduces first letter crunching)
DS=600 to 900 (Dot Size, will vary depending on air pressure)
Then press the “Enter” key twice. The current value will appear on the screen.
To change a value press “Escape” key followed by value (DS) then “:” then what number you want
to change it to.
Note you will not be able to see what you type so make sure and be carful not to make
any typing mistakes.
Example “Esc key” DS:800 “Enter twice”. If you typed everything correctly the
screen will display DS=800.
Note make sure you close out of “Hyper Terminal” before you go back into Websaw.
4. From within Websaw chose the printing options that you would like to have printed on the board
by turning the desired switch.
Note from the main screen in Websaw you can preview what will be printed.
5.Adjust the print head location in or out from outfeed roller. The further the print head is away from
the outfeed roller the better it will print on longer boards. Likewise the closer it is to the outfeed
roller the better it will print on small boards. Adjust until a happy medium is found.
Printer Preview
Printer Preview
Prints filename
on each board
Prints filename
on each board
Allows you to print
same thing on each board
Allows you to print
same thing on each board
Adjust as Necessary
Adjust as Necessary
Maintain ½ inch
clearance
Maintain ½ inch
clearance
Page 15 Printer
Summary of Contents for WebSaw
Page 1: ...TCT WebSaw...
