TCM FB-8 Series, Service Manual

Page: 242 / 259

- 80 -
4. PARAMETER SETTING
4.6 SETTING THE PASSWORDS
Two different passwords can be specified. These two passwords are factory set to “0000”.
Low-speed travel (turtle) button Switches between PASSWORD SETUP screens 1 and 2
(when pressed at the same time as the S.P.E button).
S.P.E button Switches between PASSWORD SETUP screens 1 and 2
(when pressed at the same time as the Low-Speed Travel
button).
Mode button Selects the digit to enter. Confirms the entered password.
PASSWORD INPUT SCREEN
Set “PARAMETER 3 - No.6 PASSWORD SET” to ON.
For details on the setup procedure, refer to the PARAMETER
SETTING section.
Turn on the key switch to display the PASSWORD screen
(shown on the left).
Press and hold the low-speed travel (turtle) button and S.P.E
button at the same time.
Press and hold
these buttons
simultaneously.
PASSWORD
SETUP SCREEN 1
PASSWORD SETUP screen 1 (shown on the left) will be
displayed.
To display PASSWORD SETUP screen 2, press and
hold the low-speed travel (turtle) button and S.P.E button
simultaneously while PASSWORD SETUP screen 1 is being
displayed.
Use these buttons to toggle between PASSWORD SETUP
screens 1 and 2.
The zero on the screen indicates the selected digit.
The selected digit moves to the right each time the Mode
button is pressed.
Pressing the Mode button when the selected digit is the last
digit on the right will select the digit on the far left.
Select a number (0 to 9) for each digit by pressing the “+”
button or the “–“ button.
Press and hold
these buttons
simultaneously.
PASSWORD
SETUP SCREEN 2
After entering one or two 4-digit passwords, press and hold
the Mode button for at least 3 seconds. Your password (or
passwords) will be confirmed and the Main screen will be
displayed.
You cannot specify “0000” as a valid password.
If you press and hold the Mode button when “0000” is
displayed on PASSWORD SETUP screen 1, an error will be
displayed.
If you conform “0000” as your second password by pressing
and holding the Mode button on PASSWORD SETUP screen
2, the use of a second password will be canceled and only
the first password you specified on PASSWORD SETUP
screen 1 will be valid.
KEYPAD
+ button
- button Increases or decreases the number.