TCM FB-8 Series, Service Manual

Page: 133 / 259

- 107 -
⑪
Install the rear cover in the pump body with its
gasket pointed downward.
Fig. 7.44
Fig. 7.45
Fig. 7.46
Fig. 7.48 Fig. 7.47
Direction in which oil
seal is installed.
Dust lip
Apply grease area
between oil seal lips.
Apply a thin coat
of grease on outer
diameter of oil seal.
Oil seal
Main lip
⑫
Install the four bolts and tighten them to the
specified torque:
Tightening torque: 88.3 - 98 N-m
{9 - 10 kgf-m}
[782 - 867 lbf-in.]
⑬
Remove the pump from the vice and put it on a
work bench.
Apply grease on the area between the lips
and on the outer diameter of a new oil seal.
Install it on the oil seal guide shown in Figure
7.51. Put it on the drive shaft of the pump, and
install the oil seal onto the front cover with an
oil seal snap.
7. HYDRAULIC SYSTEM