![background image](http://html1.mh-extra.com/html/tandberg/storagelibrary/storagelibrary_manual_3516504040.webp)
32
Configuring the Library
Configuring Network Settings
The Network configuration screen provides information on the network settings that are configurable
from the front panel. The network settings include:
Dynamic or static IP address
Static IP address
Static default gateway
Static subnet mask
Enable/disable RMI interface
Enable/disable RMI FW upgrade
Use the Network configuration screen to configure the library network settings. The network settings
set the connectivity of the library to the network.
If Dynamic Host Configuration Protocol (DHCP) is enabled on your network, enabling DHCP will
automatically configure the library network settings. If DHCP is not enabled on your network, you
need to manually configure the IP address, subnet mask, and default gateway settings.
Details on network settings include:
The library can be set to DHCP mode, or the IP address, subnet mask, and default gateway must
be configured. DHCP is selected by default
The IP Address, Default Gateway, and Subnet Mask text boxes are limited to numeric characters
and cannot have a value greater than 255
The paths to open the appropriate screens are:
From the front panel, select Setup Wizard > Network
After the initial setup of your library you can access the Network configuration screens directly both
from the FPI and the RMI:
From the remote management interface, select Setup > Network
From the front panel, select Setup > Network
Remote Access
If you choose to complete the Setup Wizard remotely, the FPI wizard automatically displays the
Network settings you need to access the RMI.
The network settings are also viewable from the front panel Reports > Remote Management Info
screen. The screen provides the information necessary to access the remote management interface.
The screen lists the IP address of the library. Use this IP address to access the remote management
interface using a web browser. When typing the IP address into a web browser, make sure to precede
it with “http://” (for example,
http://123.123.123.123
).
Applying a License Key
A license key is applied to the library to increase the number of available slots from 24 to 40. The
license key is applied during the initial configuration of the library or at any time in the future.
A Capacity On Demand license key can be obtained as any other product from Tandberg Data.. For
contact information, see
Getting More Information or Help
.
Summary of Contents for STORAGELIBRARY
