TallyGenicom 6605, User Manual

Page: 142 / 212

142
Chapter 7
Diagnosing Problems
ILLGL OPR ACCSS* No Illegal Operand
Accessed. Firmware
error on controller board. Contact your authorized service
representative.
1
INCOMPAT E-NET
Remove NIC
Yes Incompatible network
interface card (NIC) is
installed. Install a compatible NIC to the
printer then reboot. If this message
still appears, contact your
authorized service representative.
1
INTAKE FAN FAULT Yes Sensors cannot detect
current in fan circuit. Cycle power. If the message
appears, press CLEAR. If the
message does not clear, contact
your authorized service
representative.
1
INTERRUPT UNUSED
VECTOR 00 No The controller board
receives an interrupt it
does not understand. The
problem can be created
by electrical noise, by a
software problem, or by a
hardware problem. Cycle power. If this message
occurred once and never again, you
can ignore it. If the message
reappears or appears consistently,
contact your authorized service
representative.
1
INVALID ACTIVATE No Printer detects a twinax
protocol communication
error. Contact your authorized service
representative.
1
INVALID COMMAND No Printer detects a twinax
protocol communication
error and reports the
error. Contact your authorized service
representative.
1
LO DRV. SHORT * No Lower Driver Short.
Circuit(s) on the hammer
bank or in the hammer
bank power cable
shorted to ground. Contact your authorized service
representative.
1
LOAD PAPER Yes Printer is out of paper. Load paper and press CLEAR.
LOADING PROGRAM
FROM PORT XX% No Status message: the new
emulation program is
loading into printer RAM.
XX% indicates how much
of the program has
loaded. No action is required.
LOADING PROGRAM
INTO FLASH No The printer has deleted
the previous program
from flash memory and is
loading the new program
into flash memory. No action is required.
Table 8. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution