Paper jam (single sheets)
The print head may be hot. Please do not touch the metal part of the print
head.
When the ASF or Optional Tractor is attached, remove if necessary. Pro-
ceed with the following steps with the printer placed on a flat and stable sur-
face.
1. Turn the printer Power Switch OFF("O").
2. Open the Access Cover, and move the print head to the leftmost or
rightmost position.
3. If the top of the paper is sticking out, gently pull up on the paper while
turning the Paper Feed Knob to remove it.
4. Ensure that there are no torn paper bits remaining inside the printer, then
close the Access Cover and turn the Power Switch ON ("|").
If the problem persists, check again for any paper remaining inside the
printer.
Push back the printer cover and remove the paper manually or with the
functions LF (line feed)/FF (form feed) from the printer.
Before you replace the single sheet, refer to the instructions in Part I,
Inserting paper – single sheets.
Pay attention to the following points:
●
Set single sheet feed to the corresponding paper width.
●
Insert the paper straight as far as possible.
●
Adjust the printhead gap to the paper thickness (multiple forms, etc.). See
Part I,
Setting the printhead gap.
STOP
Troubleshooting
3 - 18
