Parameter group
Parameter
Description
Formlen
Trac.1
Lines
6 – 132 lines at 6 LPI; 72*
If Lines is selected, the form length can be adjusted by
inputting the number of lines. The basis for this is the
adjustment of the parameter group LPI. If for example the
value 4 was set under LPI, this corresponds to a line
spacing of 1/4 of an inch. If a form length of 20 lines is now
set under Lines, the form length is calculated as follows:
20 lines x 1/4 of an inch = 5 inches.
The adjustment range is between 1 and 22 inches, which at
2 LPI means 2 – 44 lines and 12 – 264 lines at 12 LPI.
If any changes are made to the LPI parameter group at a
later time, this leaves the form length unchanged, i.e. the
number of lines changes.
Standard
No Format*
DINA3 (420 mm)
DINA4 (297 mm)
DINA5 (210 mm)
DINB5 (250 mm)
DINB6 (176 mm)
DINC6 (162 mm)
Executive (10.5 inch)
Letter (11 inch)
Legal (14 inch)
Under Standard a number of different paper formats can
be selected directly, e.g. A4 Portrait, A4 Landscape, Legal,
Letter etc. If for “no format” the asterisk is displayed as the
selected setting, a form length was selected by Lines
which does not correspond to any listed standard format.
Trac.2
This form length is applicable to paper in tractor 2 only.
Lines
6 – 132 lines at 6 LPI; 72*
see Trac.1
Standard
No Format*
DINA3 (420 mm)
DINA4 (297 mm)
DINA5 (210 mm)
DINB5 (250 mm)
DINB6 (176 mm)
DINC6 (162 mm)
Executive (10.5 inch)
Letter (11 inch)
Legal (14 inch)
see Trac.1
1
4
Menu description table
1 - 19
