Parameter group
Parameter
Description
AutoTear
ViewTear=Off*
View = 1s
3s
6s
Tear = 1s
3s
6s
Tear at TOF
The
Auto-Tear function
, the
Auto-View function
or the
Tear
at TOF function
can be selected optionally.
With Auto-View switched on, the text which was printed last
can be viewed. As soon as the printer receives data, the
paper is transported back to the “normal” print position.
After the print process has been completed, the printer
waits the preset interval and then transports the paper back
to the Auto-View position.
With Auto-Tear switched on the paper starting position is in
the quick tear position, i.e. the paper’s quick tear
perforation is positioned on the printer’s quick tear edge.
As soon as the printer receives data, the paper is
transported back to the normal print position. After the print
process has been completed, the printer waits the preset
interval and then transports the paper back to the quick tear
position. If the quick tear edge is not level with the paper
perforation, this can be corrected (see
the operator’s
manual, Moving paper to the tear position
).
If
Tear at TOF
is selected instead of the AutoTear or
AutoView function, the printer feeds the fanfold paper up to
the tear edge when 1. no print data are queuing up and 2.
when the printer is in TOF position.
Width
8 inch
13.2 inch
13.6* inch
Sets the line length in inches. This parameter group is only
displayed in the menu of the wide printer.
F-Eject
Off*
ASF
Single
All
Changes the paper outfeed of cut sheets.
Off:
paper outfeed to the rear
ASF:
paper outfeed to the manual sheet feeder
Single: paper outfeed to the front
All:
Both to the manual sheet feeder
Formlen
Form length adjustment.
You can select from two different form lengths.
Trac.1
This form length is applicable to paper in tractor 1, in the
manual cut sheet feeder and in the automatic sheet feeder
(ASF).
Menu description table
1 - 18
