Talex OptiCUT 250, Original User Manual

Page: 8 / 59

TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. +48 59 821 13 40
e-mail. biuro@talex-sj.pl
https://talex-sj.pl/en
User manual
OptiCUT disc mower
Page 8 of 59

During the first operation of the machine, please check its functioning and perform
initial adjustments without any load;

To secure the three-point suspension system king pins please use only typical cotter
pins. Operating the machine with other types of securing components is prohibited;

Due to natural wear, check the condition of the cutting components and whether they
are complete, applying the suggestions described in the chapter 6. Servicing and
Maintenance;

Check the technical condition of the machine upon receipt of the mower and its
transport to make certain it did not incur any damage;

It is prohibited for any persons to be present under the lifted the mower due to the risk
of being crushed by its components;

Do not place your fingers or limbs between the components of the machine while
adjusting it;

It is prohibited to leave the cabin of the tractor while the drive is engaged, and before
the moving components come to a complete stop;

The vehicle’s operator working with the mower must be cautious so that nobody comes
near the machine and becomes present within less than 50m perimeter from the
working mower ;

Prior to engaging the mower’s drive, lower the cutting assembly to the operating
position;

Begin mowing after the nominal 540 rpm of the power-take-off is reached. It is
prohibited to overload the shaft and the mower or to rapidly switching the gear;

An appropriate visibility should be ensured or an properly trained person should be
used for that purpose while turning or reversing, maneuvering with the machine;

Mowing while reversing is prohibited . The machine should be raised while reversing;

The hydraulic system should not be under pressure when connecting the hydraulic
hoses;

The machine may be attached to the tractor only by the appropriately selected by the
manufacturer PTO shaft;

It is prohibited for any persons to be present between the vehicle and the mower while
the engine is engaged;

Operation on the slopes of more than 8% is unacceptable;

Pay extra attention while working on slopes

Disengage the PTO drive while turning or reversing;

It is prohibited to operate the machine in public places (parks, schools, etc.) or in stony
ground for the purpose of avoiding the risk of stones or other object being thrown out;

Do not allow for the PTO rotations to surpass the 540 rpm, and the speed of driving
must be adjusted to the requirements of the work;