TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. +48 59 821 13 40
e-mail.
User manual
OptiCUT disc mower
Page
30
of
59
Fig. 17
The layout of the blades depending on the rotations of the discs (view from above)
Table no. 2
RANGE OF MAX. PLAY OF THE BLADES
Luz
nominal
[mm]
acceptable
[mm]
Transverse
axial play
0,2
3,0
Longitudinal
axial play
0,1
0,4
Replacement of the blades should be performed maintaining special conditions of safety.
1.
Use only the original and efficient parts of the cutting system
2.
Every replacement considers a whole set of the disc tools. Remember about the even
layout of the rotating mass and the even wear of the blades.
3.
Inspect the condition of the cooperating components: blade holder, blade tang, and
blade. Replace with new ones if damages are observed. Fig. 18
4.
Follow the suggestions of Table nr. 3 when tightening the screw connectors, selecting
proper tightening moments of the screws and the nuts.
6.3 Post–operation maintenance
Each time after finishing work, the machine must be cleaned,
the cutting bar must be washed
under pressure,
and it should be placed on a flat, hard surface. An inspection of the
connections of parts must be performed. The damaged and worn parts should be replaced with
new ones. Inspect all screw connections and tighten the loose ones in accordance with the
Table no. 3.
THE MANUFACTURER TALEX ENSURES THE ACCESS TO ALL PARTS
