TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. +48 59 821 13 40
e-mail.
User manual
OptiCUT disc mower
Page
20
of
59
Fig. 7 Adjustment bottom link pins of suspension
After coupling the mower, lift the support, attach the connector (3,4) and adjust its length to
achieve the 4÷5˚angle to the surface. Decreasing the angle may cause increasing the height of
cut. Make sure that the original securing parts are used. Check the wear condition of the
connecting components, such as bolts and pins every time maintenance work is performed. In
case they are worn, they should be immediately replaced.
II. The assembly of the telescopic articulated shaft of the machine.
After assembling the machine on the three point suspension system, install the articulated
telescopic on the PTO of the tractor and the power input of the machine and then raise the
support to the upper position.
Use only the original articulated telescopic shaft with the one way slip clutch with the CE
sign and the power take-off and the power input shields. Check for the proper fastening of
the latches after placing the ends of the articulated telescopic shaft onto the ends of the
power take-off and the ends of the power input. Use the proper hoses ended with fitted
connectors.
III. The assembly of the hydraulic actuator.
The mower has one hydraulic lifting system. The machine is equipped with a connector,
which should be connected with the hydraulic hoses with the tractor’s power system
