TALEX Sp. z o.o.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. +48 59 821 13 40
e-mail.
User manual
OptiCUT disc mower
Page
26
of
59
6. Maintenance
All activities related to the maintenance of the machine may be performed by the user of the
vehicle, to which it is connected, under the condition, that he is authorized to operate that
vehicle.
After use machine should be stored under roof, on a flat, hardened surface with a
support.
Prior to connecting the machine to the vehicle, the operator must inspect the
technical condition of the machine each time and prepare it to the trial drive. For that purpose
the operator must:
Familiarize with this User Manual and follow the included suggestions
Learn the design and understand the functioning of the machine
Inspect all components of the machine for any possible mechanical defects
Lubricate the machine in accordance with the suggestions
Inspect the technical condition of the kingpins of the connecting system and the
securing cotter pins
Check the oil level in the gears
Inspect the tension of the gear belts
Inspect the condition of the screw connectors
Inspect the condition of the cutting blades; the worn should be replaced in pairs
Installing only the original manufacturer’s parts may guarantee the safe and reliable
operation of the device. Using generic parts or repairing damaged parts will cause loss
of warranty.
If all mentioned above activities are performed and the technical condition of the machine does
not raise any concerns, the machine may be then connected to the tractor.
Position the machine in the operating position
Adjust the length of the articulated telescopic shaft to the connected tractor in
accordance with the instructions of the shaft
Connect the articulated telescopic shaft to the tractor and the mower
Engage the drive
Engage drive of the operating shaft for 3 minutes. Check in the meantime for any:
Knocking sounds in the drive system
Vibrations in the cutting system