Takeuchi TL8, Operator'S Manual

Page: 69 / 265

2-11
CONTROLS
8. Slowly lower the lift arms until the lift arm
stopper (2) hits against the edge surface
of the cylinder tube and becomes fixed.
9. Stop the engine.
10. Insert the lock pin (1) in the front hole of
the lift arm stopper (2) and pass it
through under the cylinder rod to the
back hole.
11. To prevent the lock pin (1) from falling off,
set the hook (4) at a right angle to the
lock pin (1).
Removing the stopper
LIFT ARM STOPPER
1. Align the orientation of the hook (4) on the
tip with that of the lock pin (1).
2. Pull out the lock pin (1) from the lift arm
stopper (2).
3. Pick up the end loop of the spring (3) with
your fingers, and then hang it onto the
hook (5) of the lift arm stopper (2).
4. Sit in the seat, fasten the seat belt, start
the engine and lower the safety bar.
5. Raise the lift arms. The lift arm stopper (2)
disconnects from the cylinder rod.
6. Lower the lift arms to the ground, and
stop the engine.
7. Raise the lift arm stopper (2) to the storage
position and insert the lock pin (1) through
lift arm stopper and bracket.
8. To prevent the lock pin (1) from falling off,
set the hook (4) at a right angle to the lock
pin (1).