Tait TB9100, Installation And Operation Manual

Page: 47 / 144

TB9100 Installation and Operation Manual Installation 47
© Tait Electronics Limited May 2006
Customizing the Configuration
While the base station is still on the bench, you can configure the settings it
requires. The CTU can help you test its operation. The following steps
provide an overview of the process. For detailed information and assistance,
refer to the CSS online Help or manual.
1. Run the CSS software.
2. Check that the CSS PC is connected to the base station via an
Ethernet cable and a hub.
3. On the toolbar, click Connect . The Connections dialog box appears.
4. Click on the appropriate entry in the base station list, and then click
Connect .
5. On the toolbar, click Read to read in the configuration settings on
the connected base station.
6. On the toolbar, click Configure . The navigation tree now gives you
access to the available configuration screens.
7. Make the changes needed.
8. Click “File > Save” to save your changes, and then click Program on
the toolbar to program these changes into the base station.
Important
Make sure that you save the configuration to a file. This
provides a backup in case the configuration information
becomes lost or corrupted.
4.5 Installing the Base Station on Site
Equipment Required
It is beyond the scope of this manual to list every piece of equipment that
an installation technician should carry. However, the following tools are
specifically required for installing the TB9100 base station:
■
Pozidriv PZ3 screwdriver for the M6 screws used in the DC input
terminals on the PMU; M6 (0.25in) screws are also used to secure the
subrack to the cabinet in Tait factory-assembled systems
■
Pozidriv PZ2 screwdriver for the M4 screws used to secure the module
retaining clamps
■
0.25in or 6mm flat blade screwdriver for the fasteners used to secure the
front panel to the subrack
■
8 mm AF spanner for the SMA connectors.